EXPORTING TO 26+ COUNTRIES · MANUFACTURING SINCE 1989 +86 757 8566 5555 · SALES@JXJMACHINERY.COM EN 中文

Machine Tool Quality & Compliance

CE-Tested Milling Machines.
Full Reports on Request.

Machine safety independently assessed by Beide (Shenzhen) Product Service Ltd. in November 2024. Full test reports are available on request — including to your own compliance officer, before you place an order.

Test Reports What the CE Reports Cover Standards Applied Where Our Machines Run

Test Reports

What We Have, and What We Do Not

A CE assessment covers the safety of specific machines, decided model by model. One report does not extend across a product line, so the series still outside the current scope are listed here too rather than left for you to discover later.

Machinery Safety

EN ISO 12100:2010
EN ISO 16090-1:2022

Report B-S2410C4559 · Pass
Beide (Shenzhen) · Nov 2024

Electrical Safety

EN 60204-1:2018
Electrical equipment of machines

Report B-S2410C4561 · Pass
Beide (Shenzhen) · Nov 2024

SCOPE

Not Yet Covered

CNC lathes (CK), CNC mills (XKM)
and conventional lathes (C series)

Outside the November 2024 assessment
Tell us at enquiry stage if the destination is the EU

Ask for the reports. We will send the full PDF rather than a photograph of a certificate on a wall — the report body is where the test conditions and the assessed models are listed, and that is the part that matters to your compliance team.

Scope

Which Models the CE Reports Cover

Stated plainly, because a CE mark applied to the wrong model is worse than no CE mark at all. The November 2024 assessments cover the milling machine models listed below.

Model group	Models assessed	Machinery safety	Electrical safety
Turret milling machines	M3 · M4 · M4A · M5 · M6	B-S2410C4559	B-S2410C4561
BS series	BS-3S · BS-4B · BS-4S	B-S2410C4559	B-S2410C4561
CNC lathes (CK series)	Not in the November 2024 assessment scope. Tell us at enquiry stage if the destination is the EU and we will set out the options.
CNC milling (XKM series)	Not in the November 2024 assessment scope. Tell us at enquiry stage if the destination is the EU and we will set out the options.
Conventional lathes (C series)	Not in the November 2024 assessment scope. Tell us at enquiry stage if the destination is the EU and we will set out the options.

If you are importing into the EU or EEA, tell us at enquiry stage. The declaration of conformity has to name your exact model and configuration, and that is decided before the machine is built, not after it is on a ship.

Standards Applied

What Was Tested Against What

EN ISO 12100

Safety of machinery — general principles for design, risk assessment and risk reduction. The baseline standard: it governs how hazards on the machine were identified and what had to be done about them.

EN ISO 16090-1

Machine tools safety — machining centres, milling machines and transfer machines. The product-specific standard for this class of machine: guarding, interlocks, spindle stopping and access.

EN 60204-1

Electrical equipment of machines — general requirements. Covers the control circuit, protective bonding, emergency stop category and marking of the electrical cabinet.

Where Our Machines Run

26+ Export Markets Since 1989

Machines and SBS power feed units have been exported under our own name and under dealer labels for over three decades.

Latin AmericaSoutheast AsiaSouth Asia Middle East26+ countries since 1989

Ask for the Full Reports

Request a Quote → +86 757 8566 5555 · sales@jxjmachinery.com

Call Email Get a Quote